LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Power Brake Booster Vacuum Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Lightly coat the brake booster vacuum sensor grommet with clean engine oil before installing the sensor.
    Fig 1: View Of Brake Booster & Vacuum Sensor
    GM1703767Courtesy of GENERAL MOTORS CORP.
  1. Install the brake booster vacuum sensor grommet to the brake booster.
  2. Install the brake booster vacuum sensor to the brake booster.
    3. Fig 2: View Of Wiring Harness Electrical Connector
    GM1703744Courtesy of GENERAL MOTORS CORP.
  3. Connect the chassis wiring harness electrical connector (1) to the brake booster vacuum sensor.
scientia non olet · About LEMON Manuals