LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor (2500)
    GM1705812Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor into the line.
  3. Install the intermediate fuel and EVAP lines. Refer to Fuel Hose/Pipes Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Hose/Pipes Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Hose/Pipes Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank )  or Fuel Hose/Pipes Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) .
scientia non olet · About LEMON Manuals