LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor
    GM1704933Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) .
  2. Disconnect the evaporative emission (EVAP) line quick connect fitting from the vent valve and reposition the line out of the way. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Using a slight rocking motion while pulling straight up, remove the fuel tank pressure sensor (1).
scientia non olet · About LEMON Manuals