LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Pressure Sensor
    GM1911651Courtesy of GENERAL MOTORS CORP.
  1. Lubricate a NEW fuel pressure sensor O-ring seal with clean engine oil.
  2. Install the NEW fuel pressure sensor O-ring seal (2) onto the fuel line fitting.
  3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
    4. NOTE: Refer to Fastener Notice .
  4. Install the fuel pressure sensor (1) to the fuel line.

    Tighten:  Tighten the sensor to 15 N.m (11 lb ft).

    5. Fig 2: Chassis Wiring Harness Electrical Connector
    GM1911650Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector (1) to the fuel pressure sensor.
  6. Lower the vehicle.
  7. Use the following procedure in order to inspect for leaks:
    1. Turn the ignition ON, with the engine OFF, for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON, with the engine OFF.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals