LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (2500 - 98.4L (26 gal) Tank - Front) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Level Sensor Retaining Clip
    GM1705920Courtesy of GENERAL MOTORS CORP.
  1. Slide the fuel level sensor up onto the bucket until the sensor engages the retaining tab (1).
    2. Fig 2: View Of Fuel Level Sensor Electrical Connector
    GM1705918Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel level sensor electrical connector (1) under the module cover.
  3. Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (1500 Series)  or Fuel Tank Fuel Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Fuel Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Fuel Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)  or Fuel Tank Fuel Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) .
scientia non olet · About LEMON Manuals