LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (2500 - 43.5L (11.5 gal) Tank - Rear) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Level Sensor, Electrical Connector & Retaining Clip
    GM1705922Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (1500 Series)  or Fuel Tank Fuel Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Fuel Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Fuel Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)  or Fuel Tank Fuel Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) .
  2. Disconnect the fuel level sensor electrical connector (3) from under the module cover.
  3. Release the level sensor retaining clip (1).
  4. Slide the fuel level sensor (2) down off the bucket.
scientia non olet · About LEMON Manuals