LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.
    Fig 1: View Of EVAP Canister Purge Tube & Quick Connect Fitting
    GM1696917Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027)  or Fuel Pressure Relief (Without CH 48027) .
  2. Disconnect the fuel feed pipe (2) quick connect fitting at the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP line (1) quick connect fitting from the chassis line. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Cap the fuel rail and EVAP line in order to prevent fuel/EVAP system contamination.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    6. Fig 2: View Of Fuel Pipe Bracket & Nut At Bellhousing
    GM1238747Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel pipe bracket nut.
  7. Remove the fuel pipe bracket from the bellhousing stud.
    8. Fig 3: View Of Fuel Line Clip At Bracket
    GM1549616Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuel line clip from the bracket on the automatic transmission.
  9. If equipped with 4-wheel drive (4WD), remove the fuel hose/pipe clip from the bracket on the transfer case.
    10. Fig 4: View Of Fuel/EVAP Line Bundle
    GM1224406Courtesy of GENERAL MOTORS CORP.
  10. Remove the fuel line bracket nuts.
  11. Remove the fuel/EVAP line bundle.
scientia non olet · About LEMON Manuals