LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank (2500 LWB - 43.5L (11.5 gal) Tank-Rear) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank EVAP Lines
    GM1705754Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP lines to the fuel tank.
    2. Fig 2: View Of EVAP Line Clips
    GM1705753Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP line quick connect fittings to the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP lines to the clip (3).
  4. Install the EVAP line to the clip (2) and close the clip.
  5. Install the EVAP line to the clip (1) on the fuel tank.
  6. Install the rear fuel tank. Refer to Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) .
scientia non olet · About LEMON Manuals