LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank (1500 SWB - 98.4L (26 gal) Tank) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.
    Fig 1: View Of Fuel Tank Shield & Retainers
    GM1704741Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) .
  2. Remove the fuel tank shield retainers (2, and 3) and shields (1, and 4).
    3. Fig 2: View Of Fuel Tank Clips
    GM1704505Courtesy of GENERAL MOTORS CORP.
  3. Remove the EVAP lines from the fuel tank clips (2, and 6).
  4. Open the fuel tank clips (1, 3, 4, and 5) and remove the EVAP lines from the clips.
  5. Disconnect the EVAP line quick connect fittings at the fuel tank module and vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: View Of Fuel Tank EVAP Lines
    GM1704507Courtesy of GENERAL MOTORS CORP.
  6. Remove the EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals