LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Vent Solenoid Retainer
    GM1706536Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid.
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
    3. Fig 2: View Of Quick Connect Fittings
    GM1706533Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister vent solenoid quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel fill pipe EVAP line quick connect fitting (3) to the vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of EVAP Canister Vent Solenoid Electrical Connector
    GM1706529Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  6. Lower the vehicle.
  7. Install the spare tire and wheel assembly.
scientia non olet · About LEMON Manuals