LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: View Of Engine Wiring Harness, Clip, Bolt & Connector
    GM1696914Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system to a level below the engine cooling temperature (ECT) sensor. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Disconnect the engine wiring harness electrical connector (2) from the ECT sensor.
    3. Fig 2: View Of ECT Sensor
    GM855737Courtesy of GENERAL MOTORS CORP.
  3. Remove the ECT sensor.
scientia non olet · About LEMON Manuals