LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Resonator Outlet Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of PCV Tube
    GM1696754Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Remove the positive crankcase ventilation (PCV) line (1) from the air cleaner outlet duct.
    3. Fig 2: View Of Air Cleaner Outlet Ducts
    GM1696567Courtesy of GENERAL MOTORS CORP.
  3. Remove the radiator inlet hose clamp retainer from the outlet duct.
  4. Remove the radiator vent inlet hose retainer from the outlet duct.
  5. Loosen the air cleaner outlet duct clamp (1) at the mass air flow (MAF)/intake air temperature (IAT) sensor.
  6. Loosen the air cleaner outlet duct clamp (2) at the throttle body.
  7. Lift up the air cleaner outlet duct at the resonator tab in order to separate the resonator from the stud on the intake manifold.
  8. Remove the air cleaner outlet duct from the throttle body and MAF/IAT sensor.
scientia non olet · About LEMON Manuals