LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Underhood Electrical Center or Junction Block Bracket Replacement

Underhood Electrical Center or Junction Block Bracket Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Underhood Electrical Center/Junction Block Bracket & Screws
GM1827694Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the underhood electrical center/junction block. Refer to Underhood Electrical Center or Junction Block Replacement .
1 Underhood Electrical Center/Junction Block Bracket Screws (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Underhood Electrical Center/Junction Block Bracket
scientia non olet · About LEMON Manuals