LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Relay Replacement (Within an Electrical Center) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
  2. Locate the relay. Refer to Electrical Center Identification Views to locate the electrical center where the relay exists.
    3. IMPORTANT:
    • Always note the orientation of the relay.
    • Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
    Fig 1: Identifying Relay & Special Tool
    GM786629Courtesy of GENERAL MOTORS CORP.
  3. Using the J 43244  (1) position the tool on opposing corners of the relay (2).
    4. NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the relay (2) from the electrical center.
scientia non olet · About LEMON Manuals