LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  2. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  3. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    4. Fig 1: Inserting J 42759 Into Lock Cylinder Housing
    GM1413831Courtesy of GENERAL MOTORS CORP.
  4. Insert release tool J-42759  into the ignition lock cylinder case to release the tabs on the ignition/start switch. See Special Tools .
  5. Pull the ignition/start switch out of the ignition lock cylinder case.
  6. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About LEMON Manuals