LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Gear In Ignition Switch
    GM1413832Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The gears between the ignition/start switch and the ignition lock cylinder case must be in the correct position. Failure to do so will cause a misalignment of the gears in the ignition/start switch and the ignition lock cylinder case, which may result in a NO START or BATTERY DRAIN.
  1. Verify the alignment of the gear (1) in the ignition/start switch (2). If the gear (1) is not in the position shown then turn the gear in the ignition/start switch (2) until you reach the correct position.
    2. Fig 2: Rotating Lock Cylinder Housing Gear Using Screwdriver
    GM1413833Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: In order to reach a stop while rotating the ignition lock cylinder case gear you MUST push and hold in the solenoid on the electric park lock.
  2. Use a screwdriver to rotate the ignition lock cylinder case gear counterclockwise until it hits the stop.
  3. Connect the electrical connector to the ignition/start switch.
    4. Fig 3: View Of Ignition Switch & Lock Cylinder Housing
    GM1413834Courtesy of GENERAL MOTORS CORP.
  4. Insert the ignition/start switch into the ignition lock cylinder case. The tabs (2) on the ignition/start switch MUST be seated inside the ignition lock cylinder case (1) for proper installation.
    5. Fig 4: View Of Screwdriver Being Used To Rotate Lock Cylinder Housing Gear
    GM1413835Courtesy of GENERAL MOTORS CORP.
  5. Use a screwdriver to rotate the ignition lock cylinder case gear clockwise to the START position allowing it to spring return into the RUN position.
  6. Connect the passlock and key buzzer to the ignition lock cylinder case.
  7. Install the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  8. Install the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
scientia non olet · About LEMON Manuals