LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  2. Remove the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  3. Disconnect the park lock cable from the ignition lock cylinder case.
  4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    5. Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS CORP.
  5. Remove the 3 ignition lock cylinder case screws (2).
  6. Remove the ignition lock cylinder case (1) from the vehicle.
scientia non olet · About LEMON Manuals