LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> 175 Amp Mega Fuse Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the fuse cover.
    3. Fig 2: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  3. Remove the starter solenoid cable nut (1) from the fuse stud.
  4. Remove the starter solenoid cable terminal (2) from the fuse stud.
    5. Fig 3: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS CORP.
  5. Remove the generator battery jumper cable to fuse nut (3).
  6. Remove the generator battery jumper cable terminal (4) from the fuse stud.
  7. Remove the positive battery cable terminal from the fuse stud.
    8. Fig 4: View Of Fuse & Holder
    GM1714852Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuse from the holder.
scientia non olet · About LEMON Manuals