LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> 175 Amp Mega Fuse Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuse & Holder
    GM1714852Courtesy of GENERAL MOTORS CORP.
  1. Install the fuse to the holder.
    2. Fig 2: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS CORP.
  2. Install the positive battery cable terminal to the fuse stud.
  3. Install the generator battery jumper cable terminal (4) to the fuse stud.
    4. CAUTION: Refer to Fastener Notice .
  4. Install the generator battery jumper cable to fuse nut (3).

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    5. Fig 3: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  5. Install the starter solenoid cable terminal (2) to the fuse stud.
  6. Install the starter solenoid cable nut (1) to the fuse stud.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    7. Fig 4: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  7. Install the fuse cover.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals