LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine Cooling System) >> Repair Instructions >> Engine Cooling Fan Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The electric cooling fan assembly uses a 5-blade fan and a 7-blade fan. It does not matter which side the fan blades are installed on. DO NOT install two 5-blade assemblies or two 7-blade assemblies, as this would cause a noise issue.
    Fig 1: Cooling Fan & Retainers
    GM1505516Courtesy of GENERAL MOTORS CORP.
  1. Install the cooling fan blades.
  2. Install the cooling fan blade retainers.
  3. Install the cooling fan and shroud. Refer to Cooling Fan and Shroud Replacement (Non-HP2)  or Cooling Fan and Shroud Replacement (HP2) .
scientia non olet · About LEMON Manuals