LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Thermostat Housing Replacement (LY2, LH6, LY5, LMG, LY6) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radiator Outlet Hose
    GM1699336Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Reposition the radiator outlet hose clamp at the water pump inlet.
  4. Remove the radiator outlet hose from the water pump inlet.
    5. Fig 2: View Of Water Pump Inlet Seal
    GM1702083Courtesy of GENERAL MOTORS CORP.
  5. Remove the water pump inlet bolts.
  6. Remove the water pump inlet from the water pump.
  7. Remove and discard the water pump inlet seal.
scientia non olet · About LEMON Manuals