LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Tyco/AMP Connectors (0.25 Cap) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the component by pressing down on the connector position assurance (CPA).
    2. Fig 1: Releasing TPA Using Small Flat-Bladed Tool
    GM1459859Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The TPA on this connector cannot be removed unless the terminals are removed first. The TPA will come out of the connector body, but only slightly. When the TPA is slightly raised the terminals can be removed. Using excessive force to remove the TPA with the terminals still in the connector will damage the connector.
  2. Use a small flat-bladed tool to release the terminal position assurance (TPA) by inserting the tool in the small recess on the side of the connector and pushing up until the TPA releases from the connector body. The TPA should raise just slightly. Do not try to remove the TPA.
  3. Repeat the process for the other side of the connector.
    4. Fig 2: View Of TPA
    GM1459860Courtesy of GENERAL MOTORS CORP.
  4. Ensure that the TPA is in the proper position to remove the terminals.
    5. Fig 3: Inserting Special Tool Into Release Cavity
    GM1459861Courtesy of GENERAL MOTORS CORP.
  5. While pushing the terminal forward, insert the J 38125-24 in the release cavity above the terminal you are removing, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used. See Special Tools .
scientia non olet · About LEMON Manuals