LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Troubleshooting with a Test Lamp >> Procedure

Troubleshooting with a Test Lamp: Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The J 35616-200  is Micro-Pack compatible and comprised of a 12-volt light bulb with an attached pair of leads.

To properly operate this tool use the following procedures.

When testing for voltage:

  1. Attach one lead to ground.
  2. Touch the other lead to various points along the circuit where voltage should be present.
  3. When the bulb illuminates, there is voltage at the point being tested.

When testing for ground:

  1. Attach one lead to battery positive voltage.
  2. Touch the other lead to various points along the circuit where ground should be present.
  3. When the bulb illuminates, there is ground at the point being tested.