LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Molex Connectors >> Terminal Replacement Procedure

Terminal Replacement Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is crimped to the wire, perform the following procedure in order to replace the terminal.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is locked in place by gently pulling on the wire.
  3. To assemble the connector, reverse the connector disassembly procedure.
scientia non olet · About LEMON Manuals