Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Typical Kostal Connector

Courtesy of GENERAL MOTORS CORP.

View of typical connector.

Fig 2: View Of Connector In Released Position

Courtesy of GENERAL MOTORS CORP.

View of connector in released position.

Locate the assist lever at the back of the connector. Move the assist lever to the rear position.
Disconnect the connector from the component.

Fig 3: Using Small Flat-Blade Tool To Remove Dress Cover

Courtesy of GENERAL MOTORS CORP.

Use a small flat-blade tool to remove the dress cover.

Fig 4: Sliding Dress Cover Forward & Off Of Connector

Courtesy of GENERAL MOTORS CORP.

Slide the dress cover forward and off of the connector.

Fig 5: Locating TPA In Front & Rear Of Connector

Courtesy of GENERAL MOTORS CORP.

The terminal positive assurance (TPA) is located in the front and rear of the connector.

Fig 6: Using Small Flat-Blade Tool To Remove Rear TPA

Courtesy of GENERAL MOTORS CORP.

Use a small flat-blade tool to remove the rear TPA from the connector.

IMPORTANT: The front TPA cannot be removed from the connector. Only move it to the release point.

Use a small flat-blade tool to move the front TPA to the release position.

Fig 7: Using J 38125-213 Or J 38125-560 To Release Terminals

Courtesy of GENERAL MOTORS CORP.

Use the J 38125-213 or the J 38125-560 (GM P/N 15314260) tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used. See Special Tools .
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.