Ignition Key Cannot Be Removed from the Ignition Lock Cylinder
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that the key cannot be removed from the lock cylinder. Does the lock system operate normally? |
Go to Step 3 | System OK |
| 3 | Is the vehicle equipped with a manual transmission? | Go to Step 7 | Go to Step 4 |
| 4 | Turn the ignition key to the OFF position. Can the key be turned to the OFF position and be removed? |
Go to Step 7 | Go to Step 5 |
| 5 | Verify the adjustment of the automatic transmission cable. Refer to the appropriate procedure:
Can the key be turned to the OFF position? |
System OK | Go to Step 6 |
| 6 | Inspect the automatic transmission control assembly and cable for damage. Is the automatic transmission control assembly or cable damaged? |
Go to Step 9 | Go to Step 7 |
| 7 | Inspect for a faulty lock cylinder. Is the lock cylinder damaged? |
Go to Step 10 | Go to Step 8 |
| 8 | Inspect the ignition lock cylinder case. Is the case worn, damaged or loose? |
Go to Step 11 | Go to Step 12 |
| 9 | Replace the automatic transmission control assembly. Refer to Transmission Control Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 10 | Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 11 | Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 12 | Operate the system to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |