Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Bosch Connectors

Courtesy of GENERAL MOTORS CORP.

Locate the assist lever on the top of the connector. Move the assist lever to the forward position.

Fig 2: Identifying Assist Lever In Forward Position
Courtesy of GENERAL MOTORS CORP.
Disconnect the connector from the component.

Fig 3: Releasing Locking Tabs To Remove Dress Cover

Courtesy of GENERAL MOTORS CORP.

Locate the dress cover locking tabs at the corners of the connector. Use a small flat-blade tool to release the locking tabs and remove the dress cover.

Fig 4: View Of Terminal Positive Assurance (TPA) Connector

Courtesy of GENERAL MOTORS CORP.

The terminal positive assurance (TPA) is located in the front of the connector.

Fig 5: Removing TPA From Connector

Courtesy of GENERAL MOTORS CORP.

Use a small flat-blade tool to remove TPA from the connector.

Fig 6: Using J 38125-213 or J 38125-556 To Release Terminals

Courtesy of GENERAL MOTORS CORP.

Use the J 38125-213 or the J 38125-556 (GM P/N 12093647) tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used. See Special Tools .
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.