LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Bosch Connectors (BSK) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the component.
  2. Remove the wire dress cover, if necessary.
  3. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
    4. Fig 1: View Of Bosch Connector Terminals (BSK)
    GM1446346Courtesy of GENERAL MOTORS CORP.
  4. Insert the J 38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used. See Special Tools .
  5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
scientia non olet · About LEMON Manuals