LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Door Lock Systems & Door Handles) >> Repair Instructions >> Liftgate Close Actuator Bracket Replacement (Except Avalanche and EXT Escalade)

Liftgate Close Actuator Bracket Replacement (Except Avalanche and EXT Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liftgate Close Actuator Bracket (Except Avalanche and EXT Escalade)
GM1725899Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the body side trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) or Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) or Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) or Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) .
  2. Remove the liftgate close actuator motor control module. Refer to Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and EXT Escalade) .
  3. Remove the accessory and liftgate control module, if required. Refer to Accessory and Liftgate Control Module Replacement .
1 Liftgate Close Actuator Bracket Bolts (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  30 N.m (22 lb ft)
2 Liftgate Close Actuator Bracket
scientia non olet · About LEMON Manuals