LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Door Lock Systems & Door Handles) >> Diagnostic Information and Procedures >> DTC B153F >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the right liftgate object sensor.
  2. Test for 10K ohms between the signal terminal A and the low reference terminal B.
    • If not within the specified value, replace the right liftgate object sensor.
  3. Disconnect the harness connector at the left liftgate object sensor.
  4. Test for 10K ohms between the signal terminal A and the low reference terminal B.
    • If not within the specified value, replace the left liftgate object sensor.
scientia non olet · About LEMON Manuals