LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Connect Procedure

Connect Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution .
IMPORTANT: Clean any existing corrosion from the battery terminal and the battery cable end.
    Fig 1: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  1. Position the negative battery cable to the battery.
    2. NOTE: Refer to Fastener Notice .
  2. Install the negative battery cable onto the battery terminal.
  3. Tighten the negative cable nut (6)

    Tighten:  Tighten the nut to 5 N.m (44 lb in).

  4. Close the hood.
scientia non olet · About LEMON Manuals