LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Speed Sensor Electrical Connector
    GM860433Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the electrical connector from the speed sensor.
    3. Fig 2: View Of Vehicle Speed Sensor (VSS) & O-Ring Seal
    GM819577Courtesy of GENERAL MOTORS CORP.
  3. Remove the speed sensor and the O-ring from the transfer case.
scientia non olet · About LEMON Manuals