LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Transmission Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the catalytic converter guard. Refer to Catalytic Converter Guard Replacement .
  3. Support the transmission with a transmission jack.
  4. Remove the two nuts securing the transmission mount to the transmission support.
    5. Fig 2: Transmission Mount
    GM793590Courtesy of GENERAL MOTORS CORP.
  5. Raise the transmission off of the transmission support.
  6. Remove the bolts.
scientia non olet · About LEMON Manuals