LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Auxiliary Oil Cooler
    GM863001Courtesy of GENERAL MOTORS CORP.
  1. Install the auxiliary oil cooler to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts to the transmission fluid auxiliary cooler.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

  3. Install the transmission fluid cooler hoses to the transmission fluid auxiliary cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement 
scientia non olet · About LEMON Manuals