LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Manual Shift Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the Park/Neutral Position (PNP) Switch. Refer to Park/Neutral Position Switch Replacement .
    3. Fig 1: Sliding Seal Remover Tool Over Selector Shaft
    GM659335Courtesy of GENERAL MOTORS CORP.
  3. Be sure that the jackscrew for J 43911  is backed off and will not interfere with installation of the removal tool. See Special Tools . Slide the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal.
  4. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool is firmly attached to the seal shell.
  5. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
scientia non olet · About LEMON Manuals