LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Filler Tube and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube Nut
    GM396797Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission oil level indicator.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right hand catalytic converter. Refer to Catalytic Converter Replacement (4.8L and 5.3L Engines) .
  4. Remove the transmission heat shield bolt and shield.
  5. Remove the nut securing the oil lever indicator tube to the transmission housing.
    6. Fig 2: View Of Oil Level Indicator Tube & Seal
    GM396798Courtesy of GENERAL MOTORS CORP.
  6. Place a drain pan under the vehicle.
  7. Remove the oil level indicator tube from the transmission case and seal.
  8. Remove the seal from the transmission case.
scientia non olet · About LEMON Manuals