LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube & Seal
    GM396798Courtesy of GENERAL MOTORS CORP.
  1. Install a new seal into the transmission case.
  2. Install the oil level indicator tube into the seal.
    3. Fig 2: View Of Oil Level Indicator Tube Nut
    GM396797Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the nut securing the oil level indicator tube to the transmission stud.

    Tighten:  Tighten the nut to 18 N.m (13 lb ft).

  4. Install the transmission heat shield.
  5. Install the 2 bolts retaining the heat shield.

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  6. Install the right hand catalytic converter. Refer to Catalytic Converter Replacement (4.8L and 5.3L Engines) .
  7. Lower the vehicle.
  8. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Checking .
    9. IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  9. Reset the TAP values. Refer to Control Module References .
scientia non olet · About LEMON Manuals