LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Automatic Transmission Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Range Selector Cable End At Transmission Range Selector Lever Ball Stud
    GM738167Courtesy of GENERAL MOTORS CORP.
  1. Position the shift lever to the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Ensure the transmission manual shaft is positioned to mechanical park.
  4. Remove the range selector retaining clip and then the cable from the bracket at the transmission.
  5. Remove the range selector cable end (2) from the transmission range selector lever ball stud (1).
  6. Lower the vehicle and ensure that the shift lever is still in the park position.
  7. Remove the console. Refer to Console Replacement .
    8. Fig 2: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  8. Remove the cable end (1) from the floor shift control assembly ball stud.
  9. Remove the range selector cable (2) from the floor shift control assembly.
  10. Remove the grommet on the shift cable from the floor panel.
  11. Remove the range selector cable from the vehicle.
scientia non olet · About LEMON Manuals