LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Automatic Transmission Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  1. Route the cable through the hole in the floor panel.
  2. Ensure that the steering column shift lever is in the park position.
  3. Install the cable grommet to the floor panel.
  4. Install the cable end (1) to the floor shift control assembly ball stud.
  5. Install the console. Refer to Console Replacement .
  6. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    7. Fig 2: View Of Range Selector Cable End At Transmission Range Selector Lever Ball Stud
    GM738167Courtesy of GENERAL MOTORS CORP.
  7. Ensure that the transmission manual shaft lever is in the mechanical park position.
  8. Install the range selector cable into the bracket at the transmission.
  9. Install the cable retaining clip.
  10. Install the range selector cable end (2) to the transmission range selector lever ball stud (1).
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals