LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Automatic Transmission Range Selector Lever Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake.
  2. Shift the transmission into neutral.
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    4. Fig 1: View Of Selector Cable Bracket And Cable
    GM777649Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the transmission range selector cable from the shift lever and the bracket (2). Refer to Automatic Transmission Range Selector Lever Cable Replacement .
  5. Remove the bolts (1) securing the transmission range selector cable bracket (2) to the transmission.
  6. Remove the transmission range selector cable bracket from the vehicle.
scientia non olet · About LEMON Manuals