LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Automatic Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Console Bolts
    GM815938Courtesy of GENERAL MOTORS CORP.
  1. Remove the front floor console. Refer to Console Replacement .
    2. Fig 2: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  2. Remove the end of the range selector cable (1) from the transmission control ball stud.
  3. Remove the range selector cable (2) from the floor shift control.
    4. Fig 3: Transmission Control & Bolts
    GM745783Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission control bolts.
  5. Remove the transmission control.
scientia non olet · About LEMON Manuals