Torque Converter End Play Inspection

Tools Required

• J 8001  Dial Indicator Set
• J 26900-13  Magnetic Indicator Base
• J 35138  Converter End Play Checker. See Special Tools .
• J 39195  Converter End Play Check Tool. See Special Tools .

Fig 1: Identifying J 35138, J 26900-13 & J 8001
Courtesy of GENERAL MOTORS CORP.
1. Inspect the torque converter and replace if any of the following conditions exist:
   • Evidence of damage to the pump assembly.
   • Metal particles are found after flushing the cooler and cooler lines.
   • External leaks in the hub area.
   • Converter pilot is broken, damaged or poor fit into the crankshaft.
   • Converter hub is scored or damaged.
   • Internal damage to the stator.
   • Contamination from engine coolant.
   • Excessive end play.
IMPORTANT: The torque converter should not be replaced if the fluid has an odor, discoloration or no evidence of metal or clutch plate material.
Flushing the torque converter is not recommended.
2. Install the J 35138  , the J 26900-13  and the J 8001  or J 39195  to be used with the 300 mm torque converter. See Special Tools .

   Specification: 

   • The end play for a 245 mm torque converter should be 0-0.38 mm (0-0.015 in).
   • The end play for a 298 mm torque converter should be 0.1-0.48 mm (0.004-0.019 in).
   • The end play for a 258 mm and 300 mm torque converter should be 0.1-0.5 mm (0.004-0.020 in).

3. Remove the tools.