Reverse Input Clutch Plate Travel Check
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Apply an evenly distributed load to the clutch pack.
- Use feeler gages to check the reverse input clutch plate travel.
- Check the travel between the selective backing plate and the reverse input clutch retainer ring.
Clutch Plate Travel Specifications: The reverse input clutch plate travel should be 1.02-2.01 mm (0.040-0.079 in).
- Select the proper selective backing plate to obtain the correct travel. Refer to Reverse Input Clutch Backing Plate Selection .