LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Low and Reverse Clutch Plate Installation

Low and Reverse Clutch Plate Installation

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Illustrating Steel Plate Spline Alignment
    GM5491Courtesy of GENERAL MOTORS CORP.
  1. Install the waved plate.
  2. Install the correct selective spacer plate (from the selection procedure).
  3. Install the five fiber plate assemblies and four steel plates, starting with one fiber plate assembly and alternating with steel.
  4. Index the steel plate splines in the case as shown.
scientia non olet · About LEMON Manuals