LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Input Internal Gear, Reaction Shaft and Shell Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

J 36850  Transjel Lubricant

    Fig 1: View Of Input Internal Gear, Reaction Shaft & Sun Shell
    GM1730038Courtesy of GENERAL MOTORS CORP.
  1. Install the reaction sun shell (670) into the reaction sun gear.
  2. Install the thrust bearing (669) using J 36850  onto the reaction carrier shaft, tangs up, toward the shaft.
  3. Install the input internal gear (664) and reaction carrier shaft (666) assembly into the sun gear shell. Index the reaction carrier shaft spline into the reaction carrier.
scientia non olet · About LEMON Manuals