LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Input Housing to Output Shaft Seal Installation

Input Housing to Output Shaft Seal Installation

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Input Housing To Output Shaft Seal
GM8199Courtesy of GENERAL MOTORS CORP.

Install a new input housing to output shaft seal (636).

scientia non olet · About LEMON Manuals