LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Upper Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: If a new steering shaft coupling is being installed then transfer the position of the alignment marks from the old component to the same locations on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after installation.
  1. Install the upper intermediate steering shaft from inside the engine compartment.
    2. NOTE: Refer to Fastener Notice .
    Fig 1: View Of Upper Intermediate Shaft Pinch Bolt, Nut & Steering Column
    GM1701530Courtesy of GENERAL MOTORS CORP.
  2. Install the steering shaft coupling nut (1) and bolt (2) at the steering column.

    Tighten:  Tighten the nut and bolt to 62 N.m (46 lb ft).

  3. Install the steering column seal. Refer to Steering Column Seal Replacement .
    4. Fig 2: View Of Upper & Lower Intermediate Shafts & Components
    GM1701888Courtesy of GENERAL MOTORS CORP.
  4. Install the steering shaft coupling nut (1) and bolt (2) at the steering shaft coupling.

    Tighten:  Tighten the nut and bolt to 50 N.m (37 lb ft).

    5. Fig 3: Identifying Special Tool - J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Remove anti-rotation pin J 42640  from the steering column lower access hole.
scientia non olet · About LEMON Manuals