LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Cancel Cam Position Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
    2. Fig 1: View Of Steering Column Shaft Assembly Components
    GM1702353Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DISCARD the old steering shaft lock plate ring.
  2. Remove the following parts from the steering shaft:
    1. Steering shaft lock plate retaining ring (1) using compressor J 23653-SIR  and adapter J 42137  . See Special Tools .
    2. Turn signal switch cancel cam position plate (2)
    3. Turn signal switch cancel cam (3)
scientia non olet · About LEMON Manuals