Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Column Shaft Assembly Components

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use a NEW steering shaft lock plate retaining ring.

Install the following parts onto the steering shaft:
1. Lubricate the turn signal switch cancel cam (3) with GM P/N 12377900 (Canadian P/N 10953529).
2. Turn signal switch cancel cam position plate (2)
3. Steering shaft lock plate retaining ring (1) using compressor J 23653-SIR and adapter J 42137 . See Special Tools .
Install the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .