LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the steering column. Refer to Steering Column Replacement (Two Mode Hybrid)  or Steering Column Replacement (Non-Hybrid) .
  2. Remove the shift lever. Refer to Shift Lever Replacement .
    3. Fig 1: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ignition lock cylinder set should be in the OFF-LOCK position.
  3. Disconnect the automatic transmission park lock cable (1).
    4. Fig 2: View Of AT Shift Lock Control Actuator
    GM1858766Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.
  4. Disconnect the automatic transmission shift lock control actuator (1) from the automatic transmission control.
    5. Fig 3: View Of AT Control & Bolts
    GM1858765Courtesy of GENERAL MOTORS CORP.
  5. Remove the automatic transmission control bolts (1).
  6. Remove the automatic transmission control (2).
scientia non olet · About LEMON Manuals